Publicidad
Idiomas disponibles
Idiomas disponibles
Blade Installation
Install holder A, the tri- blade ,holder B , cover, teeth washer, in this order,
Then clamp with a left hand thread bolt.
Align hole of gear case and holder A, and insert S=4mm bar wrench.
Rotate blade-fastening bolt with plug box wrench in clockwise direction until securely tightened.
Installing plastic shield
Using four screws M5 x 26 (2) the protective device (1) fixed to the clamp (3)
Note: when installing nylon cutting head, nylon cutting head should be located in the
mat (3) above.
The nylon cutting head screw on the shaft.
FUELS/REFUELING
Fuel and oil mixture
The engine of the brush cutter is a high-efficiency two-stroke engine. It is run with a mixture of fuel and two-stroke engine oil. The engine is
designed for unleaded regular fuel with a min. octane value of 91 RON. In case no such fuel is available, you can use fuel with a higher
octane value. This will not affect the engine, but may cause poor operating behaviour. A similar situation will arise from the use of leaded
fuel. To obtain optimum engine operation and to protect your health and the environment, only unleaded fuel should be used!
For lubricating the engine use a two-stroke engine oil (quality grade: TC-3), which is added to the fuel. The engine has been designed for
use with specified two-stroke engine oil and a mixture ratio of only 30:1 to protect the environment. In addition, a long service life and a
9
Publicidad
