Publicidad
Idiomas disponibles
Idiomas disponibles
–Mowing heads, grass cutting blades and brush knives should rest lightly on the
ground.
–Circular saw blades should "hover" approx. 8 in. (20 cm) above the ground.
PUTTING INTO OPERATION
Observe the applicable accident prevention regulations.
Starting
Move at least 3m (10ft) away from the place of refueling. Place the brush
cutter on a clean piece of ground taking care that the cutting tool does not
come into contact with the ground or any other objects.
Cold start
– Push the switch to "I" position.
– Grasp the handle (hand pressure activates the safety lock-off lever (2)).
– Press the control lever (3) and hold it down.
– Press the lock button (1) and release the control lever, and then release the
lock button (the lock button holds the control lever in the start-up position).
– First place the machine on the ground.
– Give a gentle push on the primer pump (4) repeatedly (7-10 times) until fuel
comes into the primer pump.
– Move the choke lever (5) to the top position
– Firmly hold the clutch case by your left hand, as illustrated.
– Slowly pull the starter grip until resistance is felt and continue with a smart pull.
– Do not pull out the starter rope to its full extent and do not allow the starter
handle to be retracted without control, but ensure that it is retracted slowly.
– Repeat the starting operation until initial ignitions are heard.
– Depress the choke lever
– As soon as the engine starts, immediately tap and release the throttle, thus
releasing the half-throttle lock so that the engine can run in idle.
– Run the engine for approximately one minute at a moderate speed before
applying full throttle.
Caution during operation:
If the control lever is opened fully in a no-load operation, the engine rotation is increased to 10,000 min -1 or more. Never operate the
.
and pull the starter rope again until the engine starts.
11
Publicidad
