Publicidad
Idiomas disponibles
Idiomas disponibles
engine at a higher speed than required and at an approximate speed of 6,000 - 8,000 min -1 .
Starting the warm engine
– Same as above, except without moving the choke lever (choke lever remains in the down position
).
Stopping
– Release the control lever (3) fully, and when the engine rpm has lowered, push the switch to "O" position the engine will now stop.
RESHARPENING THE CUTTING TOOL
CAUTION: The cutting tools mentioned below must only be resharpened by an authorized
facility. Manual resharpening will result in imbalances of the cutting tool causing vibrations and
damage to the equipment.
– cutter blade (star blade (4 teeth), eddy blade (8 teeth), brush blade(3 teeth)) An expert
resharpening and balancing service is provided by Authorized Service Agents.
NOTE: To increase the service life of the cutter blade (star blade, eddy blade)
it may be turned over once, until both cutting edges have become blunt.
NYLON CUTTING HEAD
The nylon cutting head is a dual string trimmer head capable of both automatic and bump & feed mechanisms.
The nylon cutting head will automatically feed out the proper length of nylon cord by the changes in centrifugal force caused by increasing
or decreasing RPMS. However, to cut soft grass more efficiently, bump the nylon cutting head against the ground to feed out extra cord as
indicated under operation section.
Operation
– Increase the nylon cutting head speed to approx. 6,000 min -1 .
Low speed (under 4,800 min -1 ) is not suitable, the nylon cord will not feed out properly at low
speed.
– The most effective cutting area is shown by the shaded area.
If the nylon cord does not feed out automatically, proceed as follows:
1. Release the control lever to run the engine idle and then squeeze the control lever fully.
Repeat this procedure until the nylon cord feeds out to the proper length.
2. If the nylon cord is too short to feed out automatically with the above procedure, bump the knob
of the nylon cutting head against the ground to feed out the nylon cord.
3. If the nylon cord does not feed out with procedure 2, rewind/replace the nylon cord by following the procedures described under
"Replacing the nylon cord".
SERVICING INSTRUCTIONS
CAUTION: Before doing any work on the brush cutter, always switch off the motor and pull the plug cap off the spark plug (see "checking
the spark plug").
Always wear protective gloves.
To ensure a long service life and to avoid any damage to the equipment, the following servicing operations should be performed at regular
intervals.
Daily checkup and maintenance
– Before operation, check the machine for loose screws or missing parts. Pay particular attention to the tightness of the cutter blade or
12
Publicidad
