Domo DO934SBS Manual De Instrucciones página 38

· The appliance may not be used with an extension lead or a multiple socket.
· This cooling unit is not intended for use as a built-in appliance.
· Follow the instructions below to prevent contamination of food:
· Keeping the door open for long periods may cause the temperature in the compartments of
the appliance to rise considerably.
· Clean the surfaces that could come into contact with food regularly. Keep the condensation
channel and drainage hole at the back of the appliance clean.
· Store raw meat and fish in suitable containers in the refrigerator so that they do not come
into contact with or drip onto other food.
· If the appliance is left empty for longer periods, it should be turned off, defrosted and
cleaned. Allow it dry and leave the door ajar to prevent mould from growing in the appliance.
INSTALLATION
· Remove the exterior and interior packing, wipe the outside thoroughly with a soft dry cloth and the
inside with a wet, lukewarm cloth.
· Avoid placing the cabinet in a narrow recess or near any leave source, direct sunlight, or moisture.
· Let air circulate freely around the cabinet. Keep the rear of the refrigerator 7,5 cm away from the wall.
· Select a place with a strong, level floor.
· Avoid direct sunlight and heat. Direct sunlight may affect the acrylic coating. Heat sources nearby will
cause higher electricity consumption.
· Avoid very moist places. Too much moisture in the air will cause frost to from very quickly on the
evaporator, and your refrigerator.
· Before connecting your refrigerator to the power supply, check that the voltage stated on the rating
label of your appliance corresponds to the voltage in your home. A different voltage could damage the
appliance.
· The appliance must be grounded. The manufacturer is not responsible for damages that may occur as
a result of usage without grounding.
· For uneven surfaces, front feet can be aligned.
· After installation, leave the freezer for 24 hours before turning it on. This way the refrigerant can
settle.
· Allow the appliance to run empty for 12 hours so the compartment can cool to the appropriate
temperature.
· The climate class indicates the minimum and maximum ambient temperature for the proper operation
of an appliance. You can find the climate class on the type plate on the back of the appliance.
· SN: Subnormal: ambient temperature between 10°C and 32°C
· N: Normal: ambient temperature between 16°C and 32°C
· ST: Subtropical: ambient temperature between 16°C and 38°C
· T: Tropical: ambient temperature between 16°C and 43°C
38
DO934SBS
WARNING! Never place this appliance on or in the neighbourhood of a gas or electric fire
or in a place where it could come into contact with a heat source. There are flammable
materials located on the back of the appliance.
Pay attention to the symbol 'Fire risk – flammable materials' located on the back of the
appliance.