CLEANING & MAINTENANCE
• Always switch off the device and disconnect the power cord before cleaning.
• Let the heater cool down completely.
• Never immerse it in water or other liquid. Do not allow water to run into the
appliance.
• Clean your heater with a soft damp cloth.
• Do not use chemical materials for the cleaning of your heater.
• Clean the appliance regularly.
WARRANTY
The benefits conferred by this warranty are in addition to all implied warranties, other rights and
remedies in respect of the product which the consumer has under the Trade Practices Act and
similar State and Territory Laws. The original purchaser of this product is provided with the follow
warranty, subject to the following conditions. This product is warranted for a period of 2 years from
faulty, the product will need to be returned to the retailer where it was purchased to be replaced
free of charge or a refund issued. In order to obtain an exchange or a refund, proof of purchase
must be presented to the retailer.
DISCARDING WORN HOUSEHOLD DEVICES
The European directive 2002/96/EC pertaining to electrical and electronic waste prohibits such household goods from
being discarded with local refuse services. Worn devices must be collected separately to optimize the recovery and recycling
rates of the components therein to reduce detrimental effects on the environment and on human health.
FILTER CLEANING:
Filter becomes dirty during use, or after
30 hours usage, the indication
flashes with sounds "BE, BE, BE...". Press
OK, sounds stop while
appliance off, then remove the filter on
the back of the appliance. Clean the filter
directly under water. Do not use caustic or
abrasive material during cleaning, as this
can damage the filter. Then, have the filter
dried naturally.
Then reassemble the filter according to
the reference line (see below drawing).
Push the filter to the end until it cannot
move anymore.
Note: First,use the screwdriver to unscrew
two ST3X10 screws from filter, remove the
left and right filters. And washing with
water and dried, reassemble way is the
same as Installation point 5 method.
10
flash. Turn the