Publicidad
Idiomas disponibles
Idiomas disponibles
EFX 50/S19-2250
Supplies recommended for installation
•
Lockable shut-off on the outlet if tempered water is supplied to one or more emergency fixtures
•
Lockable shut-off on the inlets/supplies
•
(6) 3/8" wall anchors and fasteners for surface-mounted cabinet
•
(4) 1/4" fasteners (and wall anchors, if necessary) for recess-mounted cabinet
•
Unions on all connections to facilitate removal of valve
Tools required for temperature adjustment
•
5/32" Allen wrench
•
Blade screwdriver
1
Install Optional Cabinet (If not installing cabinet, skip to Step 2)
Recessed Cabinet:
1. Rough-in wall opening 24-1/2" W x 28-1/2".
2. Insert the cabinet and secure to wall with four 1/4" fasteners
properly anchored (supplied by installer.)
3. Install two anchors and screws through the valve bracket in
back of the cabinet into a secure brace (supplied by installer) or
into wall. This will support the valve.
4. Install the valve nipples and one-half of the union ball valve
using pipe sealant or teflon tape. Install the other half of the
union ball valve onto inlet and outlet pipe.
5. Insert the valve into the bracket in the cabinet (right side goes
in first). Continue with the valve installation procedure.
6. Position the wall flange tight to the wall and caulk in place.
4
8/7/2020
Surface-Mounted Cabinet:
1. Measure and mark the cabinet mounting hole locations
at the dimensions shown on next page. Install six 3/8" wall
anchors (supplied by installer).
2. Position the cabinet onto the wall and secure into place
with six 3/8" wall fasteners (supplied by installer).
3. Install the valve nipples and one-half of the union ball
valve using pipe sealant or teflon tape. Then install the
other half of the union ball valve onto the inlet and outlet
piping.
4. Insert the valve into the bracket in the cabinet (right
side of the valve goes in first). Continue with the valve
installation procedure.
Bradley • 215-1810 Rev. E: ECO 20-09-011
Installation
Publicidad
