Publicidad
Idiomas disponibles
Idiomas disponibles
EMERGENCY PROCEDURE
Every time when emergency situation occurs you should:
● switch off the working assemblies of the plate
● disconnect power supply
● call in the service
● as some minor faults can be removed by the user in accordance with the be low specified
instructions, before calling the Customer Service please go thro ugh the Table checking
every point.
PROBLEM
1.The appliance is not wor-
king
2. The appliance does not re-
spond to the entered settings
3.The appliance does not
re spond and emits a short
si gnal
4.The appliance does not re-
spond and emits a long si gnal
5.The whole appliance swit-
ches off
6. One heating zone swit-
ches off, and "H" is on the
display.
CAUSE
- power supply failure
-control panel has not been
switched on
- sensors have been to uched
for less than one se cond
- several sensors have been
to uched at the same time
- children lock has been
activated
-improper operation (im pro per
sen sors have been to uched
or pro per sensors have been
touched for too short time
- covered or dirty sensor
(sen sors)
- no settings have been en-
te red within 10 seconds from
swit ching the plate on
- covered or dirty sensor
(sen sors)
- limited time of operation
- covered or dirty sensor
(sen sors)
52
ACTION
-check the in-house electric
sys tem fuse, replace if ne-
ces sa ry
- switch it on
- touch the sensors for a bit
lon ger
- always touch only one sen-
sor (except when switching
off a hotplate)
- switch off the children lock
- again activate the plate
- uncover or clean the sen sors
- again switch on the control
panel and im me dia te ly enter
the settings
- uncover or clean the sen-
sors
- again switch on the hot pla te
- uncover or clean the sen-
sors
Publicidad
