AEG SCE81826ZC Manual De Instrucciones página 16

16 www.aeg.com
Problem
The compressor operates
continually.
The compressor does not
start immediately after
pressing the FROSTMATIC,
or after changing the tem-
perature.
The compressor does not
start immediately after
pressing the COOLMATIC,
or after changing the tem-
perature.
Water flows inside the refrig-
erator.
Water flows on the floor.
Possible cause
Temperature is set incor-
rectly.
Many food products were
put in at the same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The door is not closed cor-
rectly.
The FROSTMATIC is
switched on.
The COOLMATIC is
switched on.
The water drainage plug is
not correctly positioned.
Food products are not
wrapped properly.
Temperature is set incor-
rectly.
This is normal, no error has
occurred.
This is normal, no error has
occurred.
The water outlet is clog-
ged.
Food products prevent
that water flows into the
water collector.
The melting water outlet is
not connected to the
evaporative tray above the
compressor.
Solution
Refer to "Operation".
Wait some hours and then
check the temperature again.
Refer to climate class chart on
the rating plate.
Allow food products to cool to
room temperature before stor-
ing.
Refer to "Closing the door".
Refer to "FROSTMATIC func-
tion".
Refer to "COOLMATIC func-
tion".
Position the water drainage
plug in the correct way.
Wrap the food products bet-
ter.
Refer to "Operation" .
The compressor starts after a
period of time.
The compressor starts after a
period of time.
Clean the water outlet.
Make sure that food products
do not touch the rear plate.
Attach the melting water out-
let to the evaporative tray.