Publicidad
Idiomas disponibles
Idiomas disponibles
HC-450/HC-300 Hole Cutting Tools
Machine Storage
The Hole Cutting Tool must be kept in-
WARNING
doors or well covered in rainy weather. Store the ma-
chine in a locked area that is out of reach of children
and people unfamiliar with hole cutting tool. This ma-
chine can cause serious injury in the hands of untrained
users.
Service and Repair
WARNING
Improper service or repair can make machine un-
safe to operate.
The "Maintenance Instructions" will take care of most of
the service needs of this machine. Any problems not ad-
dressed by this section should only be handled by an au-
thorized RIDGID service technician.
Tool should be taken to a RIDGID Author ized Inde pen -
dent Service Center or returned to the factory.
For information on your nearest RIDGID Author ized
Independent Service Center or any service or repair
questions:
• Contact your local RIDGID distributor.
• Visit RIDGID.com or RIDGID.eu to find your local
Ridge Tool contact point.
• Contact Ridge Tool Technical Service Department at
rtctechservices@emerson.com, or in the U.S. and
Canada call (800) 519-3456.
12
Disposal
Parts of the Hole Cutting Tool contain valuable materials
and can be recycled. There are companies that specialize
in recycling that may be found locally. Dispose of the
com ponents in compliance with all applicable regula-
tions. Contact your local waste management authority
for more information.
For EC Countries: Do not dispose of elec-
trical equipment with household waste!
According to the European Guideline 2002/ -
96/ EC for Waste Electrical and Electronic
Equipment and its implemen tation into na-
tional legislation, electrical equipment that is
no longer usable must be collected separately and dis-
posed of in an environmentally correct manner.
999-998-050.10_REV. C
Publicidad
