Publicidad
Idiomas disponibles
Idiomas disponibles
17-1013_SPT44_SKIL_reci saw_manual_BM 2610009031 12-10 2017/10/17 11:32 页 11
POCKET CUTS
POCKET/PLUNGE CUTS
The reciprocating saw can be used to make
plunge cuts into softer material, (for example,
wood or light building materials for walls),
without a starting hole (Fig. 6).
1. Mark the line to be cut clearly on the work.
2. Set the tool with one edge of the footplate
firmly against the material.
3. Place the tip of the blade (not running) on the
line to be cut.
4. Tilt the saw so that the blade clears the work.
5. Squeeze the trigger switch and carefully
engage the moving saw blade into the
material.
6. After the blade penetrates through the work,
continue sawing along the marked outline.
To make plunge cutting easier, use a heavy
gauge blade, install the blade with the teeth
facing upward, and hold the saw upside down
as shown (Fig. 7).
Do not plunge cut in metal surfaces.
In thick materials and in harder materials,
such as metal, plunge cutting should not be
attempted. Such materials can be cut with the
recip saw only by starting the cut from the
edge of the material or from a hole drilled all
the way through the material that is large
enough to fit the saw blade.
The use of any accessories
not specified in this manual
WARNING
may create a hazard.
NOTES:
-11-
FIG. 6
FIG. 7
Publicidad
