WIKA PG23HP Serie Manual De Instrucciones página 15

5. Commissioning, operation
Mounting is only permitted in the depressurised state. Reliably
„
depressurise the instrument using the available valves and protective
devices (e.g. shut-off valve, monoflange).
Nominal position per EN 837-3 / 9.6.6 figure 7: 90° ( ⊥ ). Tolerance: ±5°
„
With parallel male threads (e.g. G ½ B) WIKA sealings must be used
„
With tapered female threads (e.g. 9/16-18 UNF) the process connec-
„
tion seals metallically without additional sealing.
When screwing the instruments in, the force required for sealing must
„
not be applied through the case, but only through the spanner flats
provided for this purpose, and using a suitable tool.
The tightening torque is dependent on the selected process
„
connection.
Sealing of the process connections
Installation with open-ended
spanner
WIKA operating instructions pressure gauge, model PG23HP
Spanner flats
Sealing face
WIKA sealing
EN
15