Lenco DIR-165 Manual Del Usuario página 11

3.1. Setup wizard
When radio is started for the first time, it runs through a setup wizard to configure settings for
date/time and network. Once this has finished, the system is ready to use in most modes.
Note: To change these settings later, select Menu > System settings > and select the required
settings options. To run the setup wizard again, select Menu > System settings > Setup wizard
The Setup wizard guides you through the basic setup parameters for Time/Date and Network
connection. To change any settings later all setting functions are accessible from the Settings Menu.
4. Operation
After the initial setup, radio is ready for operating in most Modes.
4.1. Mode selection
From the Main Menu select a mode and press OK. Alternatively press Mode button repeatedly to
switch to different mode. After a brief moment radio switches to that mode. The last station or track
previously used in that mode is selected. If this is not possible, radio scans for relevant stations,
networks, or prompts the user for appropriate input.
4.2. Audio playback
The common local controls for audio playback are available in all listening modes:
The volume rotary control is turned to increase or decrease the sound volume. The general track
controls are Play/Pause to start and stop tracks and the Next and Previous buttons to skip to the
next or previous track in the current playlist.
4.3. Menu navigation
The primary control for moving through menus and options is the knob control. Rotate the control
to move up or down a menu. Once the required option or value is highlighted press the knob control.
All menus and lists act as loops such that turning the control to go beyond the first or last entry in a
menu or list takes you to the opposite end of the menu or list. So going up from first entry in a menu
will take you to the last option in the menu, etc. A scroll bar appears on the right of the screen if
there are more options above or below those visible.
To enter the menu tree in a particular mode press Menu.
To move back a menu level press Back.
To exit the menu system, press Menu again.
11