Lenco DIR-165 Manual Del Usuario página 15

5.3.1. Network wizard
This guides you through the necessary steps to join a network. This is also automatically run as part
of the Setup wizard. The screens and options presented will depend on the type of network and
network protection used.
Selecting a network
When the Network wizard is chosen radio automatically scans for available wireless networks and
presents a list of SSID's (Service Set Identifier) for the networks. Radio remembers login details for
the last four wireless networks it has connected to and will automatically connect to them when
they are available. If connection to a network is temporarily lost, radio will automatically reconnect.
Wi-Fi network (SSID), select a network from the list.
Open network
If the network is open (non-encrypted), radio connects and no further details are required.
Standard encrypted network
If the wireless network is protected the next screen presents options to enter the network key or
passphrase.
Note: The default passphrase for most wireless routers is printed on a label on the router.
Radio connects to the selected network. If connecting fails, radio returns to a previous screen to try
again. To exit the process uses the Back/Menu button. If the network connection is lost, radio
automatically reconnects.
5.3.2. WPS setup (Wi-Fi Protected Setup)
Radio prompts you to press the connect button on the router and then press the select control. For
more information on setting up a WPS encrypted network, see your WPS router's instructions.
5.3.3. View settings
Displays the settings details for the current network setup, including:
⚫
Active connections
⚫
MAC address
⚫
Wlan region
⚫
DHCP
⚫
SSID
⚫
IP Address
⚫
Subnet mask
⚫
Gateway address
⚫
Primary DNS
⚫
Secondary DNS
5.3.4. Manual settings
Choose DHCP enable/disable
15