Publicidad
Idiomas disponibles
Idiomas disponibles
Keep the camera steady when performing the measurements.
Do not use the camera in temperatures exceeding its working and
storage temperature ranges.
Do not direct the camera toward very high intensity radiation
sources such as the sun, lasers or welding arcs etc.
Do not expose the camera to dust and moisture. When operating the
device near water, ensure that it is adequately guarded against
splashes.
When the camera is not in use or is to be transported, ensure that the
unit and its accessories are stored in the protective carry case.
Do not re-switch on the camera until 15 seconds later after switching it
off.
Do not throw, knock or shake intensely the camera and its compo-
nents in order to avoid the damage.
Do not attempt to open the camera body, as this action will void the
warranty.
Use only the SD memory card supplied with the camera.
During operation, if the camera is to be moved from hot/cold place to
cold/hot place, e.g. from inside/outside to outside/inside of a room,
switch off the camera and leave it in the new workplace for ca.
60 minutes. Only after that time, turn it on and start normal operation
with an accurate temperature measurement. Sudden and rapid chang-
es in ambient temperature may cause fault temperature measurement
and even damage camera's IR detector.
Calibration of the detector – during operation, the camera performs au-
to-calibration from time to time, which takes approx. 2 seconds.
Due to continuous development of the instrument's software,
the actual appearance of the display may slightly differ from
the display presented in this manual.
To maintain required parameters of rechargeable batteries,
unused rechargeable batteries should be charged every 3
months.
KT-128 ● KT-256 ● KT-256F – USER MANUAL
27
Publicidad
