Descargar Imprimir esta página

Protemp PT-80V-LPC Manual De Instrucciones página 11

Publicidad

Idiomas disponibles

Idiomas disponibles

CARBON MONOXIDE POISONING MAY LEAD TO DEATH!
DANGER
– Risk of indoor air pollution and Carbon
Monoxide Poisoning. Use heater only in well
ventilated areas.
– Refer to Safety Information on pages 2-3
for information about Carbon Monoxide
Poisoning.
– ALWAYS provide a fresh air opening in the
heated space of at least three square feet
(2,800 sq. cm) for each 100,000 BTU / Hr. of
heater output. Provide a larger opening if more
heaters are being used.
Always disconnect the heater from the LP cylinder
before putting the heater into storage. If for any
reason the heater is to be stored indoors, the
tank MUST be disconnected from the LP cylinder,
and the cylinder stored outdoors in a well-
ventilated area, out of the reach of children, and
in accordance with the Standard for Storage and
Handling of Petroleum Gases, NFPA 58 - latest
edition and Natural Gas and Propane Installation
Code, CSA B149.1. The plastic valve plug or valve
cover supplied with the cylinder must be re-
installed on the valve to protect the fitting from
damage.
© 2021 Pinnacle Climate Technologies, Inc.
NEVER LEAVE HEATER UNATTENDED WHILE BURNING,
CONNECTED TO A POWER SOURCE, OR WHILE
CONNECTED TO A FUEL SOURCE
VENTILATION
STORAGE / MAINTENANCE
Minimum Ventilation Opening Needed
PT-80V-LPC
2.4 ft.
2
2220 cm
2
Not for use in residential living
DANGER
areas or in non-adequately
ventilated enclosed spaces.
Never store an LP cylinder
DANGER
inside of a building or near any
other gas or oil burning appliances.
NOTE: Installation and repair of this heater
should be done by a qualified service person.
ALWAYS be sure to follow proper maintenance
procedures. This should include cleaning the
inside of the heater once a month and checking
the spark gap at least once a heating season. Re-
gap the terminals to 0.195" (4.9 mm).
11
Convection Heater User's Manual
PT-200V-LPC
6.0 ft.
2
5570 cm
2

Publicidad

loading

Este manual también es adecuado para:

Pt-200v-lpc