Publicidad
Idiomas disponibles
Idiomas disponibles
1. Remove all packing items applied to heater for
shipment. Keep plastic cover caps attached to
inlet connector and hose / regulator assembly
for storage.
2. Remove all items from carton
Attaching The Upper Housing
•
Tools Required: Phillips Screwdriver
1. Slide Upper Housing straight up and off of
lower housing and remove all packed items
from inside the heater (See Figure 2).
2. Remove all packaging protecting the heater
during shipping. Retain caps for covering the
inlet connector and regulator hose for storage.
3. Attach three (3) screws to the bottom row of
holes in the lower housing (See Figure 3).
Figure 2
© 2021 Pinnacle Climate Technologies, Inc.
NEVER LEAVE HEATER UNATTENDED WHILE BURNING,
CONNECTED TO A POWER SOURCE, OR WHILE
CONNECTED TO A FUEL SOURCE
UNPACKING
ASSEMBLY
4. Slide upper housing over lower housing, lin-
NOTE: Save carton and packaging material for
later storage.
Figure 3
7
The Propane (LP) gas pressure
CAUTION
regulator and hose assembly
supplied with the heater must be used without
alteration.
ing up the three remaining screw holes. Insert
three (3) screws and tighten securely (See
Figure 3).
Convection Heater User's Manual
Publicidad
