Tools Needed For Assembly - Bosch GTS1031 Instrucciones De Funcionamiento Y Seguridad

BM 2610014415 01-11 E:BM 2610012089 12-10 E 1/10/11 7:17 AM Page 8
lEAdINg ENd
The end of the workpiece which, during a rip type
operation, is pushed into the cutting tool first.
MOldINg
A non-through cut which produces a special shape
in the workpiece used for joining or decoration.
NON THRU-SAWINg
Any cutting operation where the blade does not ex-
tend through the workpiece (e.g. Dado, Rabbet).
pUSH STICK
A device used to feed the workpiece through the
saw during narrow ripping-type operation and helps
keep the operator's hands well away from the blade.
Use the Push Stick for rip widths less than 6 inches
and more than 2 inches.
Tools Needed for Assembly And Adjustment
HEX "L" WRENCH
(Supplied-Insert Plate)
2 MM
COMBINATION SQUARE
Disconnect plug from power source before performing any assembly, adjustment or repair
WARNING
to avoid possible injury.
pUSH blOCK
A device used for ripping-type operations too narrow
to allow use of a Push Stick. Use a Push Block for
rip widths less than 2 inches.
RAbbET
A notch in the edge of a workpiece. Also called an
edge dado.
RIppINg
A cutting operation along the length of the workpiece
cutting the workpiece to width.
REVOlUTIONS pER MINUTE (R.p.M.)
The number of turns completed by a spinning object
in one minute.
PHILLIPS SCREWDRIVER
HEX "L" WRENCH
(Supplied-Tool Adjustment)
5 MM
-8-
COMBINATION SQUARE MUST BE TRUE
STRAIGHT EDGE OF BOARD
DRAW LIGHT LINE ON
BOARD ALONG THIS EDGE.
SHOULD BE NO GAP OR OVERLAP
HERE WHEN SQUARE IS FLIPPED
OVER IN DOTTED POSITION.
3/4" THICK. THIS EDGE
MUST BE PERFECTLY
STRAIGHT.