Publicidad
Idiomas disponibles
Idiomas disponibles
COMPONENTS
1
Output shaft
2
Trigger
3
Regulator / Switch
4
Air inlet
REGULATOR
The direction of rotation and the power can be set as
follows with the regulator:
L
Output shaft rotates counter-clockwise
R
Output shaft rotates clockwise
1
Power level 1
2
Power level 2
3
Power level 3
PREPARING
1. Remove the sealing cap from the air inlet (4).
2. Mount the quick coupling nipple on the air inlet.
3. Put a few drops of compressed air device oil into the device via the air inlet.
4. Make sure that the trigger (2) is in the non-depressed position.
5. Connect the device to the compressed air source hose.
6. Check the function of the device by pressing the trigger (2).
7. Disconnect the device from the compressed air source again.
LOOSEN SCREWS
1. Choose the required size of impact socket and place the impact socket on the square of the drive
shaft (1).
2. Connect the air impact wrench to the compressed air source hose.
3. Set the regulator (3) to the position loosen.
4. Place the impact socket on the hex of the bolt or nut, hold the impact wrench and press the
trigger.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
Publicidad
