Publicidad
Idiomas disponibles
Idiomas disponibles
AIR SOURCE
Clean air at the correct pressure is essential to supply this tool. The working pressure for this tool is
specified in chapter "Technical data" and is recommended for most compressed air tools of this class.
An increase in pressure is required if the length of the air hose or other circumstances result in a
decrease in pressure. The air pressure has to be increased in order to guarantee the working
pressure at running tool. Water in the hose and compressor leads to a reduction in performance and
damage to compressed air devices.
RECOMMENDED COMPRESSED AIR SYSTEM
No.
1
Air tool
2
Air hose
3
Quick coupling
Oiler
4
(for tools with motor)
5
Pressure reducer
WARTUNG
• Air tools should be operated on air systems that have an automatic oiler.
When using air systems that do not have an automatic oiler, air tools
must be regularly added oil to the air tool via the air connection.
• Before first use, add 4 to 5 drops of air device oil to the air connection of
the device.
• Do not use engine or gear oil, to oil pneumatic tools; only use oil for
pneumatic tools.
• Drain the compressed air system before each use. Water in the air lines
leads to a loss of performance and damage to the air tool.
• Clean or replace the air filter on the compressor at the prescribed
intervals.
• Only operate the air tool with the maximum pressure specified in the
chapter "Technical data".
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Designation
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
No.
Designation
6
Drainage/filtering unit
7
Drainage valve
8
Shut-off valve
9
Dryer/filter unit
10
Compressor
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
Publicidad
