Philips Sonicare ProtectiveClean 4100 Serie Manual De Instrucciones página 24

24
English
3 Hold the top of the handle with one hand and strike
the handle housing 0.5 inch above the bottom end.
Strike firmly with a hammer on all 4 sides to eject the
end cap.
Note: You may have to hit on the end several times to
break the internal snap connections.
4 Remove the end cap from the toothbrush handle. If
the end cap does not release easily from the housing,
repeat step 3 until the end cap is released.
5 Holding the handle upside down, press the shaft
down on a hard surface. If the internal components
do not easily release from the housing, repeat step 3
until the internal components are released.
6 Wedge the screwdriver between the battery and the
black frame at the bottom of the internal
components. Then pry the screwdriver away from the
battery to break the bottom of the black frame.
7 Insert the screwdriver between the bottom of the
battery and the black frame to break the metal tab
connecting the battery to the green printed circuit
board. This will release the bottom end of the battery
from the frame.