Publicidad
Idiomas disponibles
Idiomas disponibles
18. ATTACHING THE TEMPERATURE SENSOR
Parts Required :
1
x
Temperature Sensor
Installation :
•
Insert the Smoker Temperature Sensor through the
hole on the top of the Smoker Cabinet.
•
Next attach it into the clip which is located inside top
area of the Smoker Cabinet.
See Fig. 18.1., Fig. 18.2, and Fig 18.3.
19. CONNECTING GAS COMPONENTS IN
CART ASSEMBLY
Parts Required :
1
x
Electric Wires
1
x
Electric Wires - Male Socket (end of the Electric Wires)
1
x
Electric Wires - Female Socket
Gas and Charcoal Cabinet with Lids Assembly (#13)
1
x
1
x
Cart Assembly
8
x
M6x15 mm Screws (#A)
4
x
M6x10 mm Screws (#D)
Installation :
Note: The Main Chamber must be lined up to the Trolley.
•
Carefully open the lids and attach Gas and Charcoal
Cabinet Assembly to the Cart Assembly by first fixing
the 4 pcs M6x10 mm Screws on inside first, then fix the
other 8 pcs M6x15 mm Screws later. Regulator can be
taken out at the stage for later assembly.
Use: 8 pcs M6x15 mm Screws and 4 x M6x10 mm Screws
See Fig. 19.1, Fig. 19.1A, and Fig. 19.1B.
•
Attach the Electric Wires onto two clips near the
Smoker Cabinet from the lower area of charcoal grill
side and then attach the Electric Wires Male Socket
(end of the Electric Wires) to the Female Socket which is
located on the back of Bottom Table.
See Fig. 19.2 and Fig. 19.3.
FIG. 18.1
TEMPERATURE
SENSOR
INSIDE TOP AREA OF
ELECTRIC SMOKER
FIG. 19.1
D
REGULATOR
D
13
FIG. 19.1A
A
A
VIEW HOLE
FOR LEG
SCREWS
FIG. 19.2
ELECTRIC WIRES
FIG. 19.3
MALE
SOCKET
FIG. 18.3
FIG. 18.2
FIG. 19.1B
D
D
A
VIEW HOLE
FOR LEG
SCREWS
A
VIEW HOLE FOR
LEG SCREWS
FEMALE
SOCKET
17
Publicidad
