In the other programmes the setting of
XtraDry is permanent and it is
automatically used in next cycles. This
configuration can be changed at any
time.
Every time
activated, XtraDry is off and
needs to be chosen
manually.
Activating XtraDry deactivates
TimeSaver and vice versa.
How to activate XtraDry
Press Option until the indicator
The display shows the updated
programme duration.
8. BEFORE FIRST USE
1. Make sure that the current level of
the water softener agrees with the
hardness of the water supply. If
not, adjust the level of the water
softener.
2. Fill the salt container.
3. Fill the rinse aid dispenser.
4. Open the water tap.
5. Start a programme to remove any
processing residuals that can still be
inside the appliance. Do not use
detergent and do not put dishes in
the baskets.
After starting the programme, the
appliance recharges the resin in the
water softener for up to 5 minutes. The
washing phase starts only after this
procedure is complete. The procedure is
repeated periodically.
8.1 The salt container
CAUTION!
Use rough salt designed for
dishwashers only. Fine salt
increases the risk of
corrosion.
The salt is used to recharge the resin in
the water softener and to assure good
washing results in daily use.
7.2 TimeSaver
This option increases the pressure and
the temperature of the water. The
washing and the drying phases are
shorter.
is
The total programme duration decreases
by approximately 50%.
The washing results are the same as
with the normal programme duration. The
drying results can decrease.
How to activate TimeSaver
Press Option until the indicator
The display shows the updated
is on.
programme duration.
How to fill the salt container
1. Turn the cap of the salt container
2. Put 1 litre of water in the salt
3. Fill the salt container with 1 kg of salt
4. Carefully shake the funnel by its
5. Remove the salt around the opening
counterclockwise and remove it.
container (only for the first time).
(until it is full).
handle to get the last granules inside.
of the salt container.
ENGLISH
13
is on.