Publicidad
Idiomas disponibles
Idiomas disponibles
Mounting the protector
To meet the applicable safety standards, you must only use the tool/protector
combinations indicated in the table.
Always use genuine MAKITA cutter blades/nylon cutting head.
– The cutter blade must be well polished, and free of cracks or breakages. If the
cutter blade hits against a stone during operation, stop the engine and check
the blade immediately.
– Polish or replace the cutter blade every three hours of operation.
– If the nylon cutting head hits against a stone during operation, stop the engine
and check the nylon cutting head immediately.
Star Blade
PART NO. 6258507600
PART NO. 6258507700
CAUTION: The appropriate protectors must always be installed for your own
safety and in order to comply with accident-prevention regulations.
Operation of the equipment without the guard installed is prohibited.
– Fix the protector (1) to the clamp (3) with two M6 x 30 bolts (2).
– When using the string head, fit the protector (6) into the protector (1), and
tighten them with two nuts (5) and two screws (4).
Eddy Blade
Protector for metal blades
PART NO. 6258065000
Nylon cutting head
PART NO. 6218016000
(6)
11
Protector for cord cutter
PART NO. 6258064000
(2)
(3)
(1)
(4)
(1)
(5)
Publicidad
