Progress Lighting AirPro P250073 Manual De Instalación página 10

Installing Fan to
the Electrical Box
WHEN USING THE STANDARD BALL/DOWNROD
MOUNTING, THE TAB IN THE RING AT THE
BOTTOM OF THE MOUNTING BRACKET MUST
REST IN THE GROOVE OF THE HANGER BALL.
FAILURE TO PROPERLY SEAT THE TAB IN THE
GROOVE COULD CAUSE DAMAGE TO WIRING.
1. Pass the 120-volt supply wires through the
center hole in the ceiling mounting bracket
as shown in Figure 14.
2. Install the ceiling mounting bracket on the
electrical box by using the mounting screws
provided with the electrical box. Note that
the flat side of the mounting bracket is
toward the electrical box. (Figure 14)
3. Tighten the two screws on the electrical box
securely.
4. Carefully lift the fan assembly up to the
ceiling mounting bracket. Make sure the tab
on the mounting bracket is properly seated
in the groove in the hanger ball. (Figure 15)
7.
UL Listed
Electrical
Box
Ceiling
Mounting
Bracket
Hook
120V Wires
Standard mounting
Washers
Mounting
Screws
(Supplied with
Electrical Box)
Figure 14
Figure 15