GE GUD27EE Manual De Usuario página 8

Getting started - Washer
Start
B
Press Start to begin the cycle. With the lid closed pressing Start again will pause the cycle and Status lights will blink.
To continue the cycle, close the lid and press Start again. The water fill will continue with the lid opened, except when
Precise Fill (on some models) is selected as the load size. The lid must be closed to continue filling when Precise Fill
(on some models) is selected.
If the lid is opened during the cycle, the cycle will pause and the Status lights will blink. To resume the cycle, close the
lid and press Start.
If the machine is paused for more than 24 hours, the cycle will be cancelled. To stop the cycle, turn the Cycle
Selector to the Off position. NOTE: Machine will automatically cancel and drain when water is present and the
lid is left open for 15 minutes or the unit is left in a paused state for 24 hours with the lid closed. Select cycle and
press Start to begin new cycle.
Display
C
Remaining Time Will display the time left for the washer to complete the current cycle.
Connected
Lid Lock
Deep Fill
D
Select the Deep Fill feature for loads where extra water is needed.
Press the Deep Fill button once before starting the cycle to add an incremental amount of water to the wash
load. Holding the Deep Fill button for 3 seconds will provide the deepest fill level possible; this will increase cycle
time due to the additional time it takes to fill the washer.
To cancel the option if desired, press the Deep Fill button again.
NOTE: The Deep Fill button can also be pressed after the washer has completed filling and is in the wash phase
if additional water is desired. To stop the extra fi ll, press the Deep Fill button again and the water will stop.
Temperature
E
Select the water temperature for the washer cycle (all rinses use cold water). Always follow fabric manufacturer's
care label or instructions when laundering.
Tap Cold* uses incoming tap water, which can provide energy savings. For all other temperature selections, a
mixture of hot and cold water is used to achieve the ideal temperature for each temperature setting.
*Note that some detergents do not fully dissolve in very cold water. If you experience this, it is recommended you
choose a setting other than Tap Cold.
WiFi
Press and hold the Temp button for 3 seconds to activate the Wi-Fi connection. If the washing machine is
already connected (Wi-Fi light on) press 3 seconds to disconnect the Wi-Fi connection (LED blinks while it is in
the process of connecting).
Cycle Options
F
Auto Soak
This option begins with a brief agitation, soaks for a specified period, then moves through the rest of the cycle
automatically.
Repeated pressing of the Auto Soak button will scroll through 15 minute, 30 minute, 60 minute, 2 hours (2h)
selections and then return to 0 soak minutes.
Deep Rinse
Set this option to provide a deep rinse or when using fabric softener. It may change other settings (e.g., Spin
may go to a higher setting) to maximize performance.
Remote Enable
Press and hold the Auto Soak and Deep Rinse buttons for 3 seconds to activate Remote Enable (Connected
will come on and AP will blink in the display).
Press the Start button and AP will stop flashing and stay on. Then, from the App, you can modify the scheduled
start time from 24 to 00 hours or remote start the washer cycle.
NOTE: This function is only for the washer cycles.
8
Will be on once the washer is connected with your App.
It will be on while the lid is locked.
It will be on once your washer is connected to WiFi.
WiFi
49-3000359 Rev 0