Descargar Imprimir esta página

GE GUD27EE Manual De Usuario página 9

Ocultar thumbs Ver también para GUD27EE:

Publicidad

Idiomas disponibles

Idiomas disponibles

Getting started - Washer
Status lights
G
The Status lights show the stage the washer is in. When the selector knob is set to a new cycle, the Status
lights will flash momentarily, showing the stages the cycle will go through.
NOTE: If the Status lights are blinking, the operation of the washer has been paused. To resume operation press
the Start button (the lid must be closed).
Consumer Help Indicator
Your washer is equipped with Consumer Help Indicator (CHI). CHI is our way to communicate a simple remedy for some
situations that you can perform without the need to call for service. The chart below describes the helpful lights you may
notice flashing on the display.
Spin and Rinse
If an out-of-balance condition is detected by the washer, the Spin and Rinse lights will blink during
lights blinking
the remaining portion of the cycle and will stay illuminated for a short time after cycle completion. When
this occurs, the washer is taking actions to correct the out-of-balance condition and complete the cycle
normally. In some cases, the washer may not be able to balance the load and spin up to full speed. If
you notice the load is more wet than normal at the end of the cycle, redistribute the load evenly in the
wash basket and run a Drain & Spin cycle.
Wash and Rinse
Check your house water supply. Did you forget to turn on one or both supply valves after installation or
lights blinking
coming back from vacation? As soon as the lights start to flash, the washer will initiate a 4 minute lock-out
(Water not
period. The washer controls won't respond/change during this time. After the 4 minutes, you can begin
entering washer)
your cycle again. If you try to bypass the lock-out period by unplugging the washer, the 4 minute timer will
start over again.
Lid Locked light
Lid Locked light will flash if 3 cycles have been started without opening the lid. The washer will not start
another cycle until the lid is opened. Try opening, then closing the lid and starting a new cycle. If the
problem persists, call GE Appliances at 800.GE.CARES (800.432.2737) for service.
49-3000359 Rev 0
Status light
Wash
When the washer is in the wash portion of the cycle.
Rinse
When the washer is in the rinse portion of the cycle.
Spin
When the washer is draining and/or spinning.
Illuminates
9

Publicidad

loading

Este manual también es adecuado para:

Gud27eesnww