x
Notes on using the camera
Internal memory and "Memory
Stick Duo" media back up
Do not turn off the camera, remove the battery
pack, or remove the "Memory Stick Duo"
media while the access lamp is lit. Otherwise,
the internal memory data or "Memory Stick
Duo" media may be damaged. Be sure to make
a backup copy to protect your data.
Notes on recording/playback
Before you start recording, make a trial
•
recording to make sure that the camera is
working correctly.
•
The camera is neither dust-proof, nor splash-
proof, nor water-proof. Read "Precautions"
(page 52) before operating the camera.
Avoid exposing the camera to water. If water
•
enters inside the camera, a malfunction may
occur. In some cases, the camera cannot be
repaired.
Do not aim the camera at the sun or other
•
bright light. It may cause the malfunction of
the camera.
Do not use the camera near a location that
•
generates strong radio waves or emits
radiation. Otherwise, the camera may not
properly record or play back images.
Using the camera in sandy or dusty locations
•
may cause malfunctions.
If moisture condensation occurs, remove it
•
before using the camera (page 52).
Do not shake or strike the camera. It may
•
cause a malfunction and you may not be able
to record images. Furthermore, the recording
media may become unusable or image data
may be damaged.
Clean the flash surface before use. The heat
•
of flash emission may cause dirt on the flash
surface to become discolored or to stick to
the flash surface, resulting in insufficient
light emission.
Notes on the LCD screen and lens
The LCD screen is manufactured using
•
extremely high-precision technology so over
99.99% of the pixels are operational for
effective use. However, some tiny black and/
or bright dots (white, red, blue or green) may
appear on the LCD screen. These dots are a
normal result of the manufacturing process,
and do not affect the recording.
When the battery level becomes low, the lens
•
might stop moving. Insert a charged battery
pack and turn on the camera again.
On camera's temperature
Your camera and battery may get warm due to
continuous use, but it is not a malfunction.
On the overheat protection
Depending on the camera and battery
temperature, the power may turn off
automatically to protect the camera.
A message will be displayed on the LCD
screen before the power turns off.
On image data compatibility
The camera conforms with DCF (Design rule
•
for Camera File system) universal standard
established by JEITA (Japan Electronics and
Information Technology Industries
Association).
Sony does not guarantee that the camera will
•
play back images recorded or edited with
other equipment, or that other equipment will
play back images recorded with the camera.
Warning on copyright
Television programs, films, videotapes, and
other materials may be copyrighted.
Unauthorized recording of such materials may
be contrary to the provisions of the copyright
laws.
No compensation for damaged
content or recording failure
Sony cannot compensate for failure to record
or loss or damage of recorded content due to a
malfunction of the camera or recording media,
etc.
9
GB