Selecline HS-384CN(S3N) Manual De Instrucciones página 15

Fault
The lid does not close
properly.
The lid is hard to open.
The temperature inside
the freezer is too high/
The temperature inside
the freezer is too low.
The temperature inside
the freezer is too high.
The temperature inside
the freezer is too high.
Potential cause
There is too much frost
and ice.
The lid seal is not clean.
The lid seal is not clean.
The temperature is not
properly regulated.
The lid does not close
tightly or is not closed
properly.
Before freezing, the
temperature inside the
appliance was not cold
enough.
Too many fresh products
have been put inside the
appliance.
The food put into the
appliance was too hot.
The products to be frozen
are placed too close to
one another.
The lid has been opened
too often.
The lid has been left open
for a long time.
The temperature is not
properly regulated.
15
Solution
Defrost the appliance.
Clean the lid seal.
Clean the lid seal.
Select a lower
temperature.
Check that the lid closes
correctly and that the seal
is in good condition and
clean.
Allow the appliance to
cool down while empty
for a sufficient period of
time.
Please wait for a few
hours and check the
temperature again.
Next time, put smaller
quantities of food into
the freezer at the same
time.
Allow the food to
cool down to room
temperature before
storing them.
Space out the products
so that air can circulate
between them.
Avoid opening the lid too
often.
Do not leave the lid open
for longer than necessary.
Select a higher
temperature.