Selecline MR-101 Manual Del Usuario página 9

5. On the top right of the appliance, remove the hinge cover and three screws then remove
the top hinge.
6. On the top left of the appliance, remove the four hole covers then screw the top hinge into
the holes.
7. Place the door back into the top hinge pin.
8. Fix the door stop onto the bottom left of the appliance using the screw.
9. Secure the door on the bottom left using the two screws.
10. Replace the foot on the bottom right of the appliance.
11. Stand the appliance in a vertical position. Plug the appliance to the wall outlet.
Climate Range
Install this appliance at a location where the ambient temperature corresponds to the climate
class indicated on the rating plate of the appliance. This ensures the correct operation of the
appliance.
Climate class
SN
N
ST
T
Locks
If the refrigerator is fitted with a lock, keep the key out of reach and not in the vicinity of
the appliance to prevent children being entrapped. Before the disposal of an old refrigerator,
break off its lock or latches as a safeguard.
Electrical connection
Before plugging in, ensure that the voltage and frequency shown on the rating plate
correspond to your domestic power supply. The appliance must be earthed. The power supply
cable plug is provided with a contact for this purpose. If the domestic power supply socket is
not earthed, connect the appliance to a separate earth in compliance with current regulations,
consulting a qualified electrician.
The manufacturer declines all responsibility if the above safety precautions are not observed.
Hinge cover
3x screw
Hinge
Ambient temperature
+10°C to +32°C
+16°C to +32°C
+16°C to +38°C
+16°C to +43°C
9
EN