Publicidad
Idiomas disponibles
Idiomas disponibles
What to do if the descaling procedure is interrupted
Warning icons and error codes
Meaning of the warning icons
Fill the water tank with fresh
water to the MAX level
indication.
ADD WATER
The bean hopper is empty.
Put new coffee beans in the
bean hopper.
ADD COFFEE
The brew group is not in the
machine or it is not inserted
correctly. Insert the brew
group.
The hot water dispensing
spout is not installed. Insert
the hot water dispensing
INSERT
WATER SPOUT
spout.
If the display shows an error
10
code, check section 'Meaning
of the error codes' to see
SUPPORT REQUIRED
what the code on the display
means and what you can do.
The machine cannot be used
when this icon is on the
display.
Once the descaling procedure has started, you must let the machine
perform the entire procedure until the very end without switching off the
machine. If the machine gets stuck during descaling, you can exit the
descaling procedure by pressing the standby button. If this occurs, or in case
of a power failure or accidental disconnection of the cord, do the following:
1 Empty and rinse the water tank thoroughly.
2 Fill the water tank up to the CALC CLEAN level indication and switch the
machine back on. The machine will heat up and perform an automatic
rinsing cycle.
3 Before brewing any beverages, perform a manual rinsing cycle.
Note: If the descaling procedure was not completed, the machine will
require another descaling procedure as soon as possible.
The warning icons are displayed in red. Below you find a list of the warning
icons that may appear on the display and their meaning.
The milk carafe is not installed.
Insert the milk carafe into the
machine.
INSERT CARAFE
The coffee grounds container
is full. Make sure the machine
is switched on. Then remove
and empty the coffee grounds
container.
The brew group is blocked by
coffee powder. Clean the brew
group.
Insert the drip tray and close
the service door.
English
23
Publicidad
