Publicidad
4. Emergency stop: It is used to stop the machine in case of emergency.
5. Angle adjustment wheel: It is used to regulate the accuracy of the angle that we cannot get with the
plate pivot. Its function is also to advance or retreat the bar mandrill support.
6. Pedal: It is used to confirm the bending plate rotation when it has been intentionally pressed (Fig.3).
7. Tension Entry: Electrical tension entry to the machine.
3.4 PARTS OF THE PLATE
The bending plate has 3 holes to insert the thrust bolt. Hole 1 is used with the spirals device. Hole 2 is used to
bend rods equal or smaller than 16mm diameter with the bolts and mandrels system. Hole 3 is used to bend rods
greater than 16mm diameter with the bolts and mandrels system. Threaded holes 4 serve as fans to extract and
dismantle the plate. Fig.6
NOTE: In rebar processing, the bar thrust must always be done with a mandrill put in the bolt. (Fig.7)
3.5 ANGLE INVERSION AND SELECTION PIVOT
The inversion pivot (Fig. B) It is used to select the plate rotation angle. Depending on the rotation direction
of the plate that we choose, we have to insert the pivot in different sectors.
4. STARTING-UP AND USING THE MACHINE
WARNING: All safety recommendations must be followed, either the ones mentioned in the present user
manual or those complying with all labour risks prevention norms in every location.
WHEELWORK: SIMA bending and combined machines do not need any wheelwork operations as they are
specially designed to obtain the maximum performance from start.
NORMAL USE OF THE MACHINE:
The bending machines have been designed for bending and cutting flat and reinforced steel bars for use in the
structure and other construction components is in conformity with all applicable provisions of the Directive of Machines
(98/37/CE) and the national applicable regulations
considered abnormal. Any tool or accessory added or amended without written authorization from the manufacturer is
considered inappropriate and dangerous. If any damage or injury is caused as a result thereof or by misuse of the
machine, SIMA S.A. exempts all responsibility as manufacturer. The machine must be installed on a plane, firm and
horizontal surface and the ground should not be soft. This machine DOES NOT HAVE TO BE USED UNDER THE
RAIN. ALWAYS WORK IN WELL ILLUMIINATED AREAS.
.
Each other use that has not been expressively indicated is
7
ENGLISH
Publicidad
