Cembre SD-9P-ECO Manual De Uso Y Mantenimiento página 9

5.1) Removing the "MND" spindle
– Remove the detachable guard PRM-UN and the auger (see § 4.1.1).
– Turn the fixed guard (23) and remove from the spindle, exposing the spindle shaft (15).
– By means of the 4 mm allen key supplied with the machine, remove grubscrew (18).
– Remove circlip (16) and locating pin (17).
– Slide the spindle from the shaft (13).
5.2) Fitting the "MND1" spindle
– Slide the "MND 1" spindle onto the shaft (15). Ensure that the spindle guide (19) is correclty po-
sitioned.
– Align the hole on the shaft (13) with the corresponding holes on the spindle (20).
– Insert the locating pin (17) and fit the circlip (16).
– Fit and tighten the grubscrew (18).
– Fit the fixed guard (23).
– Insert and secure the auger (Ø 16 mm shank); (see § 5.3).
– Fit the detachable guard PRM-UN (see § 4.1.2).
5.3) Fitting and removing the auger on the "MND1" spindle
– Turn the emergency lever (12), align the two grooves
on the auger with the red reference line on the end
of the spindle and fully insert the auger.
– Release the emergency lever (12).
To remove the auger, turn the emergency lever (12)
extract the auger from the spindle.
6. MAINTENANCE
Before servicing or removing any parts, stop the engine and allow it to cool.
Always remove the spark plug cap from the spark plug when servicing the engine
to prevent accidental starting.
Periodic inspections are essential for the proper functioning of the engine;
refer to "KAWASAKI" manual provided with the machine for the safe use of the
engine and for further requested maintenance operations.
6.1) ROUTINE MAINTENANCE OF THE MACHINE
6.1.1) Lubrication
Depending on ambient conditions and use, periodically lubricate the return spring shafts, pro-
ceeding as follows:
– Remove the detachable guard PRM-UN and the springs.
– Carefully clean the shafts using a clean cloth soaked in kerosene.
– Lubricate the shafts with a general purpose oil.
– Re-assemble the springs and detachable guard..
9
Grooves on the
auger
Red reference line
on the spindle
ENGLISH