Publicidad
20/25N
30
EMU00854
N
PROCEDURE FOR TILLER CONTROL
MODEL
4) Place the gear-shift lever in the neu-
NOTE:
The start-in-gear protection device pre-
vents the engine from starting except
when in Neutral.
406012
5) Place the throttle control grip in the
503022
6) Attach the engine stop switch lanyard
w
8 Attach the engine stop switch lanyard
to a secure place on your clothing, your
407016
arm or leg while operating.
8 Do not attach the lanyard to clothing
that could tear loose. Do not route the
lanyard where it could become entan-
gled, preventing it from functioning.
8 Avoid accidentally pulling the lanyard
during
engine power means the loss of most
steering control. Also, without engine
power, the boat could slow rapidly.
This could cause people and objects in
308013*
the boat to be thrown forward.
3-16
tral position.
"START" position.
to a secure place on your clothing, or
your arm or leg. Then, install the lock
plate on the other end of the lanyard
in the engine stop switch.
normal
operation.
GB
Loss
of
Publicidad
