Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION
Tips for the installer
The installer must:
●
Have appropriate qualification
●
Read the information on the nameplate
or information sticker concerning the
type of gas, for which the appliance is
intended. This information must be com-
pared with the gas supply specification
at the place of installation.
●
Check
- effectiveness of ventilation, i.e. ex-
change of air in the room.
- tightness of gas fittings.
- proper operation all the functional com-
ponents.
●
For proper operation of igniters and
flame failure cut-off device, adjust the
position of the gas knobs with the sup-
plied washers,
- check the operation of igniters and flame
failure cut-off device,
- In the event of faulty operation, remove
the knob, make adjustments by inserting
a washer (washers) on the valve pin,
- once adjusted, protect the system with a
clamping washer and replace the knob.
●
Provide the user with the gas hob instal-
lation certificate and give instructions on
the appliance operation.
CAUTION!
Only a qualified person must con-
nect the appliance to a liquid gas
cylinder or an existing system, fol-
lowing all safety regulations.
36
The appliance has an G 1/2" threaded pipe
connector to connect it to the gas system.
The LPG (propane-butane) hob version has
the connector terminated with a hose tip
8 x 1 mm.
Gas supply hose should not touch the metal
parts of the cover.
ENSURE the connections are tight.
Once you install the appliance,
check all connections for leaks, for
example using soapy water.
Do not use fire to check the con-
nections.
Carefully read the operating in-
structions supplied and follow all
guidelines.
C A U T I O N !
You are dealing with gas. The appli-
ance must be supplied with the type
of gas specified by the manufacturer.
Only a qualified person must in-
stall the appliance.
Information on the type of gas for
which the appliance is designed is
given on the nameplate.
∅
Publicidad
