Publicidad
Enlaces rápidos
T380 Professional Airless Spray Gun
For TRAINED, PROFESSIONAL USE ONLY!
Part No. 501-155 shown in illustration above.
!! SAFETY and OPERATING INSTRUCTIONS INSIDE !!
Read all warnings and safe operating information inside
MADE IN THE U.S.A.
OWNER'S MANUAL
SAVE THIS MANUAL FOR FUTURE REFERENCE
Maximum Working Pressure:
3800 PSI - 262 BAR - 26.2 Mpa
T380 With Hose Swivel:
4-Finger Trigger with Tip and Guard:
7/8" Guard Connection - 501-150
11/16" Guard Connection - 501-251
2-Finger Trigger with Tip and Guard:
7/8" Guard Connection - 501-155
11/16" Guard Connection - 501-255
Publicidad
Manuales relacionados para Tritech T380
Resumen de contenidos para Tritech T380
- Página 1 MADE IN THE U.S.A. OWNER'S MANUAL T380 Professional Airless Spray Gun Maximum Working Pressure: 3800 PSI - 262 BAR - 26.2 Mpa For TRAINED, PROFESSIONAL USE ONLY! T380 With Hose Swivel: 4-Finger Trigger with Tip and Guard: 7/8" Guard Connection - 501-150 11/16"...
- Página 2 WARNING Keep clear of nozzle “Do not exceed maximum working pressure.” Safety Precautions WARNING HAZARD: Injection injury - A high pressure stream produced by this equipment can pierce the skin and underlying tissues, leading to a serious injury and possible amputation. See a physician immediately.
- Página 3 - Always flush unit into a separate metal container, at low pump pressure, with spray tip removed. Hold gun firmly against side of container to ground container and prevent static sparks. - Follow the material and solvent manufacturer's warnings and instructions. - Use extreme caution when using materials with a flashpoint below 70°...
- Página 4 TriTech replacement parts only. - Do not alter or modify equipment. - Use equipment only for its intended purpose. Call TriTech for more information. - Route hoses and cables away from traffic areas, sharp edges, moving parts and hot surfaces.
- Página 5 Aktivieren Sie immer die Pistolenauslösersperre, wenn die Pistole nicht verwendet wird. Bevor Sie die Ausrüstung warten, schlagen Sie in den Ausrüstungshandbüchern nach und befolgen alle Warnungen Trigger Lock Gâchette Seguro de gatillo Auslösersperre Safety Guard Dispositif de sécurité T380 Portaboquillas Sicherheitschutz...
- Página 6 T380 Professional Airless Spray Gun Pail Hook T93R Tip Rear Access Cap T93R Tip Guard Filter Inside Handle Trigger Trigger Lock Trigger Guard Hose ConnectionSwivel or Hose connection Hose Connection Fitting inlet fitting (1/4" NPS) (Depending on model) Part No. 503-150 shown in illustration above.
- Página 7 If the T380 spray gun model you own came with the tip included, follow the instructions below to install the guard and tip. If you are using a different tip, follow the installation instructions provided with the tip you are using.
- Página 8 Druck, um die gewünschte Zerstäubung zu erreichen. Tip Clogs If you are using a TriTech T93R tip, follow the instructions on the next page to clear a clogged tip. If you are using a different tip, follow the instructions Déboucher la included in the equipment manual provided with that tip.
- Página 9 Tip Clogs 1. Engage trigger Lock. Rotate tip handle 180° to the reverse position. 2. Unlock trigger. Point the gun into a bucket holding the gun away from you. Déboucher la Trigger the gun briefly to expel the clog. buse 3.
- Página 10 Handle is hand tight. Unscrew and remove the handle from the head of the gun. T380 Débrancher le tuyau de fluide de la base du pistolet. À l'aide d'une clé à 3/4" ou 19mm ou d'une clé à molette réglable. La poignée est à la main.
- Página 11 Apriete bien con una llave de 13/16" o 21 mm o con una llave ajustable. Reconecte la manguera de líquidos. OBSERVACIÓN: Utilice únicamente piezas de repuesto y filtros originales de TriTech, para mantener la pistola en el mejor estado de funcionamiento posible y asegurar la cobertura de garantía. La Spring utilización de piezas no fabricadas por TriTech anulará...
- Página 12 Il est fortement recommandé d'utiliser le nettoyeur à système mit TriTector sans air TriTector (pièce TriTech n° 400-010) pendant le rinçage final. Mantener limpia la pistola es importante para asegurar un funcionamiento sin problemas y prolongar la vida útil del aparato. Después de cada, lave bien la pistola y guárdela en un lugar templado y seco.
- Página 13 Replacing the valve stem assembly Remplacement de l'unité de la tige de vanne Cambio del conjunto de vástago de válvula Ersetzung der Ventilschaftanordnung Locked Relieve fluid pressure from your entire spray system. Engage trigger Verrouillée lock and disconnect fluid hose from gun. Remove tip and guard. Bloqueado Décompresser l'ensemble du système de pulvérisation.
- Página 14 Apply grease to the o-ring on the new seal housing. Use ONLY nonsilicon grease. Appliquer de la graisse sur le joint torique du nouveau logement de joint. N'UTILISER que de la graisse sans silicone. Aplique grasa en la junta tórica del nuevo alojamiento del sello. Utilice ÚNICAMENTE grasa sin siliconas.
- Página 15 For a complete list and information on all TriTech products, visit our website at www.tritechindustries.com or call toll-free in the USA 866-387-4832 or direct at +908-378-1080. Pour obtenir des informations et la liste complète des produits TriTech, rendez-vous sur notre site Internet www. Tritechindustries.com ou appeler notre numéro vert aux Etats-Unis 866-387-4832 ou directement au +908-378-1080.
- Página 16 Parts Drawing for your T380 Spray Gun Schémas des pièces pour le Pistolet Pulvérisateur T380 Diagrama de piezas de la pistola de pulverización T380 Teilezeichnung für Ihre T380 Spritzpistole T3680 With Hose Swivel: 4-Finger Trigger with Tip and Guard: 7/8" Guard Connection - 501-150 11/16"...
- Página 17 * Parts included in Repair Kit part No. 503-092...
- Página 18 Parts Drawing for your T93R Spray Tip and Guard Schémas des pièces pour l Buse et le garde-buse du Pulvérisateur T93R Diagrama de piezas de la boquilla y portaboquillas (protector) T93R Teilezeichnung für Ihre T93R Spritzdüse und Schutz Parts List: Item Part# Description...
- Página 19 Technical Data for your T380 Spray Gun Données techniques pour le Pistolet Pulvérisateur T380 Información técnica de la pistola de pulverización T380 Technische Daten für Ihre T380 Spritzpistole Maximum Working Pressure..............3800 PSI (262 bar, 24.5 Mpa) Weight ..........................15.2 oz. (431 g) Hose Inlet Connection....................
- Página 20 (12) months after sale to the original purchaser. This warranty applies only when the product is installed and operated in accordance with the instructions of TriTech. This warranty does not apply in the case of damage or wear caused by abrasion, corrosion or misuse, negligence, accident, faulty installation, substitution of non-TriTech component parts, or tampering with the product in a manner that will or has impair(ed) normal operation.