Publicidad
Idiomas disponibles
Idiomas disponibles
this is the case, press the "Start/Pause/Cancel" button to
resume the drying cycle after draining the water tank.
*To drain the water tank:
1-Pull the drawer and remove the water tank carefully.
2-Drain the water in the tank
3-If there is lint accumulation in the funnel of the water
tank, clean it under running water.
4-Place the water tank into its seat.
For the condenser;
Hot and humid air in the condenser is cooled with the
cold air from the room. Thus, the humid air circulating in
your dryer is condensed and then pumped into the tank.
C
Clean the condenser after every 30 drying cycles or
once a month.
To clean the condenser:
1. If a drying process has been carried out, open the door
of the machine and wait until it cools down.
2. Unlock the 2 condenser locks after opening the kick
plate.
3. Pull out the condenser.
4. Clean the condenser by applying pressurized water
with a shower armature and wait until the water
drains.
5. Place the condenser in its housing. Fasten the 2 locks
and make sure that they are seated securely.
17 EN
Publicidad
