Blue/white
Connect to system control terminal of
the power amp (max. 300 mA 12 V DC).
Light green
Used to detect the ON/OFF status of the
handbrake. This lead must be
connected to the power supply side of
the handbrake switch.
Power supply side
Handbrake switch
Earth side
Speaker leads
To power supply
Power cord
Left
Right
Front speaker
Rear speaker
White
White/black
Grey
Grey/black
Green
Green/black
Violet
Violet/black
8
En
NOTE
With a two-speaker system, do not connect
anything to the speaker leads that are not
connected to speakers.
Power amp (sold separately)
Important
The speaker leads are not used when this connection is in use.
Subwoofer output (SUBWOOFER OUT L/SUBWOOFER OUT R)
RCA cable (sold separately)
Power amp
Front output (FRONT OUT L/FRONT OUT R)
Rear output (REAR OUT L/REAR OUT R)
Yellow/black (MUTE)
If you use an equipment with Mute function, wire this lead to the Audio Mute lead on
that equipment. If not, keep the Audio Mute lead free of any connections.
Pre out cord
To pre out supply
To connector 1
System remote control
Connect to Blue/white cable.
Rear speaker
Front speaker