Hart HGCS01 Manual Del Operador página 15

OPERATION
To install:
NOTICE:
When placing battery pack in your chain saw,
be sure raised rib on battery pack aligns with
groove in chain saw's battery port and latch
snaps in place properly. Improper assembly
of battery pack can cause damage to internal
components.
 Place the battery pack in your chain saw. Align
raised rib on battery pack with groove in chain
saw's battery port.
WARNING:
Make sure the latch on the battery pack
snaps in place and the battery pack is fully
seated and secure in the battery port before
beginning operation. Failure to securely seat
the battery pack could cause the battery pack
to fall out, resulting in serious personal injury.
To remove:
Locate latch on back of battery pack and depress
to release the battery pack from the chain saw.
For complete charging instructions, see the opera-
tor's manuals for your battery pack and charger.
STARTING/STOPPING THE CHAIN SAW
See Figure 8.
WARNING:
Keep body to the left of the chain line. Never
straddle the saw or chain, or lean over past
the chain line. Improper operation of the chain
saw could result in serious personal injury.
Starting the chain saw:
 Place the chain saw on a flat bare surface and
make sure no objects or obstructions are in im-
mediate vicinity which could come in contact
with the bar and chain.
 Press and hold the lock-out button. This makes
the switch trigger operational.
 Press and hold the switch trigger, release the
lock-out button and continue to squeeze the
switch trigger for continued operation.
FIG. 8
SWITCH
TRIGGER
LOCK-OUT
SWITCH
TRIGGER
Stopping the chain saw:
 Release the switch trigger to stop the chain saw.
 Upon release of the switch trigger, the lock-out
button will be automatically reset to the lock
position.
This cordless chain saw is designed for limbing
and pruning type cutting up to 6 in. in diameter
only.
15 – English
LOCK-OUT
BUTTON
BUTTON