Hart HGCS01 Manual Del Operador página 24

MAINTENANCE
DEPTH GAUGE CLEARANCE
See Figure 29 - 31.
 The depth gauge should be maintained at a
clearance of .025 in. Use a depth gauge tool
for checking the depth gauge clearances.
 Every time the chain is filed, check the depth
gauge clearance.
Use a flat file and a depth gauge jointer to lower
all gauges uniformly. Depth gauge jointers are
available in .020 in. to .035 in. Use a .025 in. depth
gauge jointer. After lowering each depth gauge,
restore original shape by rounding the front. Be
careful not to damage adjoining drive links with
the edge of the file.
Depth gauges must be adjusted with the flat file in
the same direction the adjoining cutter was filed
with the round file. Use care not to contact cutter
face with flat file when adjusting depth gauges.
MAINTAINING THE GUIDE BAR
See Figure 32.
CAUTION:
Make sure the chain has stopped and the
battery pack has been removed before you
do any work on the saw to avoid accidental
starting or contact with the moving chain that
may result in injury.
Proper maintenance will maximize the useful life
of the guide bar.
Each day of use:
Clean the bar and check for wear and damage.
Feathering or burring of the bar rails is a normal
process of bar wear, but such faults should be
smoothed with a file as soon as they occur.
Each week of use:
 Reverse the guide bar on the saw to distribute
the wear.
 Lubricate the socket at the end of the guide bar
using a grease syringe in the lubricating hole.
 Turn the guide bar and check that the lubrication
holes and chain groove are free from impurities.
FIG. 29
FIG. 30
DEPTH GAUGE
JOINTER
FIG. 31
FIG. 32
A bar with any of the following faults should be
replaced immediately:
 Wear inside the bar rails that permits the chain
to lay over sideways
 Bent guide bar
 Cracked or broken rails
 Spread rails
24 – English
RAKER CLEARANCE
.025 in.
FLAT FILE
RESTORE ORIGINAL
SHAPE BY ROUNDING
THE FRONT
SPROCKET
LUBRICATION HOLE
LUBRICATION HOLES