Airwell DDMX-022N-09M25 Manual De Usuario E Instalacion página 34

12.To avoid getting an electric shock, never
touch the electrical components soon
after the power supply has been turned
o . After turning o the power, always
wait 10 minutes or more before you touch
the electrical components.
13. Make sure that you do not cross your
electrical wiring with your signal wiring.
This may cause distortion and
interference.
14. The unit must be connected to the
main outlet. Normally, the power supply
must have a impedance of 32 ohms.
15. No other equipment should be
connected to the same power circuit.
16. Connect the outdoor wires before
connecting the indoor wires.
WARNING
BEFORE PERFORMING ANY
ELECTRICAL OR WIRING WORK,
TURN OFF THE MAIN POWER TO
THE SYSTEM.
NOTE ON AIR SWITCH
When the maximum current of the air
conditioner is more than 16A, an air switch or
leakage protection switch with protective
device shall be used(purchased seperately) .
When the maximum current of the air
conditioner is less than 16A, the power cord
of air conditioner shall be equipped with
plug (purchased seperately) .
In North America，the applicance should be
wired according to NEC and CEC requirements.
Air switch
(A)
(purchased seperately)
Outdoor unit power wires
Outdoor unit
(B)
(C)
(D)
NOTE: The cographs are for explanation
purpose only. Your machine may be
slightly di erent. The actual shape shall
Indoor & Outdoor
prevail.
connective wires
(purchased seperately)
Indoor unit
Indoor unit power wires
Outdoor unit
Indoor & Outdoor
connective wires
(purchased seperately)
Air switch
(purchased seperately)
Indoor unit power wires
Outdoor unit power wires
Outdoor unit
Indoor & Outdoor
connective wires
(purchased seperately)
(Only for the North American)
Air switch
(purchased seperately)
Outdoor unit power wires
Outdoor unit
Air switch
(purchased seperately)
Air switch
(purchased seperately)
Indoor unit
Air switch
(purchased seperately)
Indoor unit
Indoor & Outdoor
connective wires
(purchased seperately)
Indoor unit
Page 33
 