Publicidad
Idiomas disponibles
Idiomas disponibles
OBJ_BUCH-0000000029-001.book Page 12 Wednesday, February 16, 2011 8:27 AM
en
12
Changing the tool.
Before mounting or replacing
WARNING
application tools or accesso-
ries, remove the battery. This
preventive safety measure rules out the dan-
ger of injuries through accidental starting of
the power tool.
For all work or when changing
CAUTION
application tools, always wear
protective gloves. Danger of injury from the
sharp edges of the application tools. Applica-
tion tools can become very hot while work-
ing. Danger of burns!
The application tool can be offset in 45° steps
and fastened in the most favourable working
position.
Protect your hand and fingers
CAUTION
against bruising them when
locking the clamping lever. The clamping
lever snaps back vigorously by means of
spring force.
Release the clamping lever and tilt it to the
stop.
Pull out the fastening element.
Clean the tool holder, the application tool and
the fastening element.
Mounting or replacing a sanding sheet
(figure 5).
Align the sanding sheet and press it manually
against the sanding pad.
Press the power tool with the sanding sheet
briefly and firmly against a flat surface and
briefly switch the power tool on. This pro-
vides for good adhesion and prevents prema-
ture wear.
When only one tip or corner of the sanding
sheet is worn, it can be removed again and
reattached turned by 120°.
Insert the application tool accurately into the
star-shaped tool holder. Pay attention that the
application tool is mounted flush.
Firmly press in the fastening element to
the stop. Then lock the clamping lever.
Publicidad
