Orbegozo CVT 3300 Manual De Instrucciones página 16

CVT 3300
OPERATION OF THE HEATER
NOTE: It is normal when the heaters are turned on for the first time or when they are turned on after
having not been used for a long period of time the heaters may emit some smell and fumes. This
will disappear when the heater has been on a short while.
 Choose a suitable location for the heater, taking into account the safety instructions above.
 Insert the plug of the heater into a suitable socket.
 Turn THERMOSTAT KNOB fully in a clockwise direction to
the maximum setting.
 Turn on the heating elements by means of HEATER
SWITCHES on the side panel. When the heating elements
are on the switches will illuminate. For maximum heat
output both switches should be on.
 When the desired room temperature has been reached,
the thermostat knob should be turned slowly anti-
clockwise until the thermostat is heard to click off and the
lights on the element switches are seen to go out. After
this the heater will keep the air temperature in the room
at the set temperature by switching on and off
automatically.
CLEANING THE HEATER
Always un-plug the heater from the wall socket and allow it to cool down before cleaning.
Clean the outside of the heater by wiping with a damp cloth and buff with a dry cloth. Do not use
any detergents or abrasives and do not allow any water to enter the heater.
STORING THE HEATER
When the heater is not used for long periods of time it should be protected from dust and stored in
a clean dry place.
16