Dometic Marine Climate System MCS10 Instrucciones De Montaje página 29

MCS5, MCS10, MCS15
➤ Connect all metallic parts in contact with seawater to the vessel's
bonding system including
– the speed scoop inlet,
– pump (the harness ground wire),
– the air conditioner.
9 Connecting the Marine Climate System
!
WARNING!
Turn off AC power supply circuit breaker before opening electrical box
and accessing the terminal strip.
I
NOTE
Failure to properly ground and bond the system will void the warranty!
Key to the wiring diagrams (fig. 8, page 7):
Item
1
2
3
4
5
6
7
8
9
10
11
12
13
14
The following guidelines should be followed during the connection of the
Marine Climate System:
 The correct size circuit breaker should be used to protect the system
as specified on the air conditioning unit's data plate label.
 Install and ground/bond AC power source in accordance with marine
electrical standards.
EN
Connecting the Marine Climate System
Description
Electrical box
Positive Temperature Coefficient Resistor (PTCR) start assistant
(not used with MCS5)
Run capacitor
Control panel
Optional alternative air sensor
Optional outside air sensor
Compressor
Pump or relay panel
Reversing valve
Fan
High Pressure switch
Power supply
System grounding point
Power in and Pump out terminals
29