Publicidad
Idiomas disponibles
Idiomas disponibles
EN
10
MAINTENANCE
Read and understand the safety regulations and the
maintenance instructions before you clean, repair or do the
maintenance work on the machine.
Make sure that all nuts, bolts and screws are tight. Examine
regularly that you install the handles tightly.
Use only the replacement parts and accessories of the initial
manufacturer.
10.1
GENERAL INFORMATION
Only your dealer or approved service center can do the
maintenance that is not given in this manual.
Before the maintenance operations:
•
Stop the machine.
•
Remove the battery pack.
•
Cool the motor.
•
Store the machine in cool and dry place.
•
Use correct clothing, protective gloves and safety glasses.
10.2
CLEAN THE MACHINE
•
Clean the machine after use with a moist cloth dipped in
neutral detergent.
•
Do not use aggressive detergents or solvents to clean the
plastic parts or handles.
•
Keep the trimmer head free of grass, leaves, or excessive
grease.
•
Keep the air vents clean and free of debris to avoid
overheating and damage to the motor or the battery.
•
Do not spray water onto the motor and electrical
components.
10.3
INSTALL THE CUTTING LINE
Do not put more than 15 feet of cutting line in at a time.
1. Remove the remaining cutting line on the spool.
2. Line up the slots on the spool cap with the slots on the
trimmer head.
IMPORTANT
IMPORTANT
IMPORTANT
IMPORTANT
NOTE
English
Spool
cover
3. Put the cutting line through the hole. Push the cutting line
until it exits the opposite hole.
4. Pull the cutting line through until there is an equal
quantity of cutting line on each side.
5. Turn the spool cap counterclockwise to wind the cutting
line into the trimmer head. Keep approximately 5 in of
cutting line above out of each side of the trimmer head.
10
Bump
head
Hole
Publicidad
