Descargar Imprimir esta página

GreenWorks ST40L02 Manual Del Operador página 9

Ocultar thumbs Ver también para ST40L02:

Publicidad

Idiomas disponibles

Idiomas disponibles

9.5
OPERATION TIPS
WARNING
Keep clearance between the body and the machine.
WARNING
Do not operate the machine without guard in place.
Do these tips when you use the machine
Keep a firm hold with the two hands on the machine
while you operate the machine.
Cut tall grass from the top down.
If grass winds around the trimmer head:
Remove the battery pack.
Remove the grass.
9.6
CUTTING TIPS
Tilt the machine toward the area to be cut. Use the tip of
the cutting line to cut grass.
Move the machine from right to left to prevent thrown
debris from hitting the operator.
Do not cut in the danger area.
Do not force the trimmer head into uncut grass.
Wire and picket fences cause cutting line wear and
breakage. Stone and brick walls, curbs, and wood can
wear the cutting line quickly.
English
9.7
ADJUST THE CUTTING
DIAMETER
The machine is set at a 14" (356 mm) cutting diameter. You
can adjust to a 16" (406 mm) cutting diameter.
Set the cutting diameter to 14" (356 mm) for greater
runtime and 14" (356 mm)for a larger cutting area.
1. Remove the battery pack.
2. Remove the blade screws from the cut-off blade (1).
3. Turn the cut-off blade 180°.
4. Tighten the blade screws.
9.8
LINE CUT-OFF BLADE
This trimmer is equipped with a line cut-off blade (1) on the
guard. The line cut off blade continuously trims the line to
ensure a consistent and efficient cut diameter. Advance line
whenever you hear the motor running faster than normal, or
when trimming efficiency diminishes. This will maintain best
performance and keep line long enough to advance properly.
9
NOTE
1
EN

Publicidad

loading

Este manual también es adecuado para:

Stf456