Hitachi CG 23ECP Instrucciones De Manejo página 7

MEANINGS OF SYMBOLS
NOTE: Some units do not carry them.
Symbols
WARNING
The following show symbols used for the machine. Be sure that you understand their meaning before use.
Brush Cutter / Grass Trimmer
It is important that you read, fully understand
before use, and observe the following safety
precautions and warnings. Careless or improper
use of the unit may cause serious or fatal injury.
Read, understand and follow all warnings and
instructions in this manual and on the unit.
Always wear eye, head and ear protectors when
using this unit.
Do not use metal/rigid blades when this sign is
shown on the unit.
Keep all children, bystandards and helpers
15 m away from the unit. If anyone approaches
you, stop the engine and cutting attachment
immediately.
Be careful of thrown objects.
Shows maximum shaft speed. Do not use the
cutting attachment whose max rpm is below the
min
-1
shaft rpm.
Gloves should be worn when necessary, e.g.,
when assembling cutting equipment.
Use anti-slip and sturdy footwear.
Choke – Run position (Open)
Choke – Start position (Closed)
START
On/Start
STOP Off /Stop
Fuel and oil mixture
Idle speed adjustment
Priming pump
000Book̲CG23ECP(SL).indb 7 000Book̲CG23ECP(SL).indb 7
(Original instructions)
Guaranteed sound power level
Blade thrust may occur when the spinning
blade contacts a solid object in the critical area.
A dangerous reaction may occur causing the
entire unit and operator to be thrust violently.
This reaction is called blade thrust. As a result,
the operator may lose control of the unit which
may cause serious or fatal injury. Blade thrust is
more likely to occur in areas where it is diffi cult
to see the material to be cut.
Hot Surface – Contact with hot surface can
cause serious burns.
Indicate handle location. Arrows which show
limits for handle positioning.
Displacement
Spark plug
Idling speed
Idle
Speed of output shaft
P
Max. engine output
Fuel tank capacity
Dry weight (without fuel, cutting attachment,
harness and cutting attachment guard)
Cutting attachment
L
Sound pressure level LpA by ISO 22868
pA, eq
Equivalent*
ISO22868
Measured sound power level LwA by 2000/14/
L
WA, Ra(M)
EC
2000/14/EC
Racing
Guaranteed sound power level LwA by
L
WA, Ra(G)
2000/14/EC
2000/14/EC
Racing
7
English
2016/04/25 14:00:48 2016/04/25 14:00:48