Seca 285 Manual De Instrucciones Y Garantía página 81

Install the third column
element
7. Use the two cable clips to fix the connection cable
into the groove of the column element.
8. Swivel the multifunctional display so that you can
easily read it.
To connect the column elements, proceed as follows:
1. Screw a threaded rod hand-tight into the elongated
nut of the second column element.
2. Push the column element over the threaded rod
onto the upright connector of the second column
element.
3. Position the end cap on the second column
element so that the threaded rod protrudes from
the hole of the end cap.
4. Place the plain washer on the free end of the
threaded rod.
5. Place the nut on the free end of the threaded rod.
6. Tighten the nut.
7. Place the decorative cap on the nut.
Before you get started ... • 81
English