Stihl RE 80 X Manual De Instrucciones página 58

English
7.5 Attaching and removing the nozzle
7.5.1 Attaching the Nozzle
2
► Push nozzle (1) onto the spray lance (2).
► Turn the nozzle (1) until it engages
► If the nozzle (1) cannot be pushed easily into the spray
lance (2): Grease the gasket on the nozzle (1) with grease
for fittings.
7.5.2 Removing the nozzle
2
► Press nozzle (1) and spray lance (2) together and turn
until stop.
► Pull nozzle (1) and spray lance (2) apart.
56
1
1
8 Connecting to a water source
8.1 Connecting the high-pressure washer to the
mains water supply
Connecting the water filter
If the high-pressure washer is operated with sandy water or
water from cisterns, a water filter must be connected to the
high-pressure washer. The water filter filters sand and dirt
out of the water and thus protects the components of the
high-pressure washer from damage.
Depending on the market, the water filter may be included
with the high-pressure washer.
► Unscrew the connector (1).
► Screw the water filter (2) onto the water supply and tighten
by hand.
► Screw the connector (1) onto the water filter (2) and
tighten by hand.
Connecting the water hose
The water hose must meet the following requirements:
– The water hose has a diameter of 1/2".
– The water hose is between 10 m and 25 m long.
► Connect the water hose to a tap.
8 Connecting to a water source
1
2
0458-001-9821-A