Publicidad
Idiomas disponibles
Idiomas disponibles
REPLACING THE SCRAPER
WARNING:
To avoid serious personal injury,
always turn your unit off and unplug it before you
perform maintenance.
Use only original equipment manufacturer replacement
parts.
1. Place the unit on the ground or on a work bench.
Position the unit so the vanes and rotor are facing up.
2. Beneath the rotor, locate the three (3) screws securing
the scraper to the housing. Remove them using a
#T20 Torx bit or flat blade screwdriver (Fig. 11).
3. Remove the scraper and discard it appropriately.
4. The new scraper will snap into place. Once in place,
attach it to the unit by reinstalling the three (3) screws.
Torque the screws to:
STORAGE
•
Allow the motor to cool before storing.
•
Store the unit locked up to prevent unauthorized use
or damage.
•
Store the unit in a dry, well-ventilated area.
•
Store the unit out of the reach of children.
12
MAINTENANCE AND REPAIR INSTRUCTIONS
25-30 in•lb (2.8-3.3 N•m)
Scraper
Fig. 11
CLEANING
WARNING:
To avoid serious personal injury,
always turn your unit off and unplug it before you
clean or service it.
Use a small brush to clean off the outside of the unit. Do
not use strong detergents. Household cleaners that
contain aromatic oils such as pine and lemon, and
solvents such as kerosene, can damage plastic housing
or handle. Wipe off any moisture with a soft cloth.
TRANSPORTING
•
Allow the motor to cool before transporting.
•
Secure the unit while transporting.
•
To move the unit, grasp it by the top and middle
front handles (Fig. 12).
•
If you are transporting the unit with the handles
folded, be careful not to make contact and
accidentally bend the discharge directional control
(Fig. 6). If you bend or damage the control, you can
no longer adjust the vanes.
Fig. 12
Publicidad
