MTD YARD-MAN 769-02494A Manual De Instrucciones página 13

UNIT WILL NOT START
C A U S E
Unit is unplugged
Starter button or bail were improperly used
Overload protection switch has popped out
MOTOR IS ON, BUT ROTOR WILL NOT TURN
C A U S E
Belt is damaged
UNIT LEAVES A THIN LAYER OF SNOW ON PLOWED SURFACES
C A U S E
Scraper is worn
If further assistance is required, contact your authorized service dealer
MOTOR*
Motor type ...............................................................................................................................................................A.C.,120 Volts Electric
Operating RPM .............................................................................................................................................................. up to 14,000 rpm
Ignition Switch ...................................................................................................................................................... Bail Lock Safety Button
Amperage .................................................................................................................................................................................... 8.5 amps
Overload Protection.................................................................................................................................................120V, 15 amp Breaker
DRIVE SHAFT ASSEMBLY AND SNOW THROWER UNIT*
Handles .................................................................................................................................................................................... Steel Tube
Approximate Unit Weight ..................................................................................................................................................... 20 lbs. (9 kg.)
Snow Depth (maximum)........................................................................................................................................ 6 inches (0.152 meters)
Cleared Path Width............................................................................................................................................. 12 inches (0.318 meters)
*All specifications are based on the latest product information available at the time of printing. We reserve the right to make changes
at any time without notice.
TROUBLESHOOTING
A C T I O N
Check cord to make sure it is plugged into an electrical outlet
Press in starter button, hold it, and hold bail
Push it in and follow the Starting Instructions
A C T I O N
Replace the belt, according to Inspecting/Replacing the
Driver Belt
A C T I O N
Replace the scraper
SPECIFICATIONS
13